Analysis calculator
General single-span beam analysis.
Create a free account to use it
7 days of the Professional plan, no card. After the trial the account moves to the Free plan; nothing is charged automatically.
What it checks
Reactions, maximum bending moment and shear, and elastic deflection for a uniform and/or point load on a simply-supported, cantilever, propped-cantilever or fixed-end beam.
Inputs
Analysis takes 9 inputs for the Australia and New Zealand code system, with the defaults below. Lengths are in m, forces in kN and stresses in MPa unless the unit column says otherwise.
| Input | Unit | Default |
|---|---|---|
| Model | ||
| Support condition Options: Simply supported; Cantilever; Propped cantilever (UDL); Fixed-fixed. | - | Simply supported |
| Geometry | ||
| Span L | m | 6 |
| Loads | ||
| UDL w | kN/m | 10 |
| Point load P | kN | 0 |
| P position from left a | m | 3 |
| Section | ||
| EI source Options: Library steel section; Enter E and I manually. | - | Library steel section |
| Section type Options: UB; UC; PFC; UBP; TFB; CHS; SHS; RHS. | - | UB |
| Designation | - | 310UB40.4 |
| Bending axis Options: Major (I_x); Minor (I_y). | - | Major (I_x) |
Results and report
The module reports: Max moment; Max shear; Max deflection.
It checks: Maximum moment; Maximum shear; Adopted section.
Each module produces a report: numbered working, formulas with substituted values, tables and diagrams, ready to attach to a calculation package. The report carries a verification code that confirms it was made by TensorNode and has not been changed.
Example with the default inputs
Analysis with its default inputs for the Australia and New Zealand code system. The main inputs:
| Input | Value |
|---|---|
| Support condition | Simply supported |
| Span L | 6 m |
| UDL w | 10 kN/m |
| Point load P | 0 kN |
| P position from left a | 3 m |
| EI source | Library steel section |
| Section type | UB |
| Designation | 310UB40.4 |
Headline results:
| Result | Value |
|---|---|
| Reactions R1 / R2 | 30.0 / 30.0 kN |
| Max moment | 45.0 kNm |
| Max shear | 30.0 kN |
| Max deflection | 9.8 (L/614) mm |
Governing check: Deflection δ vs span/250 (AS/NZS 1170.0 serviceability), δ 9.8 mm (span/614) against limit span/250 = 24.0 mm, utilisation 0.41, passes.
Computed by TensorNode with the default inputs shown; a qualified engineer checks every result.
Design codes
Analysis works to 1 code system in Australia and New Zealand. The standards and editions are listed below; clause numbers are cited in the report.
| Region | Standard and edition |
|---|---|
| Australia and New Zealand | Statics (AS/NZS 1170.0) |
Use it in full during the 7-day trial of the Professional plan. Paid plans give access to the module packs. TensorNode is a calculation aid. Every result must be checked and accepted by a qualified engineer, who remains responsible for the design. Read the scope and limits of this module before you rely on a result.
Related modules
- Section Properties
Section property calculator - Earthquake Design Category
Earthquake Design Category (EDC) determination to AS 1170.4 §2 - Static Analysis
Equivalent static earthquake analysis to AS 1170.4
Open Analysis with a free account
7 days of the Professional plan, no card. After the trial the account moves to the Free plan; nothing is charged automatically.